Are you a CCNP or CCIE student looking to challenge your perfect knowledge of Catalyst switchport commands?
Take the latest SWITCH Command Recall exam by clicking the link below. Good luck – and let us know how you scored in the comments area of this post.
Remember to read, AND TYPE, very carefully! I failed my first attempt due to just plain sloppiness. 
About INE Instructor:
You can leave a response, or trackback from your own site.
14 Responses to “SWITCH Command Recall Exam – L2/L3 Ports”
Leave a Reply
Nice work Jay! That is a passing score. Had you forgotten the exact syntax of some of those – or was it just “fat finger” issues?
80%
100%
Wow – Edmund! Way to go!
Sweet 100%. Studying is paying off!
60%
70%
70%
. No good excuse! In any case, many thanks as was a good refresher!
90%
80%…helps I’m doing the CCNP CoD workbook right now for switching
Got 90%, but with did not accept show int f0/0 switchport, told to be specific with writing show interface fa0/0 switchport
100%
70% because of typos (90% knowing that the abbreviated commands and tab would have corrected it)
80% – Didn’t read the full question on two of them. Got to remember to slow down.