Posts Tagged ‘r&s workbook’
The beta version of lab 1 for the R&S CCIE Volume III Workbook has been released. It’s available in your members’ site account for customers with access to the workbook.
Additionally the initial configurations are available per section. This means you can load up to a particular section. For example you could load up to the BGP section or up to 4.6 where route redistribution start. Also the final configurations are available to load on the racks.
Note that the configurations are at the bottom of the drop down for the R&S rack rentals in the control panel.
Once this is finalized I’ll submit it to be automatically graded like our Troubleshooting Labs are now and also put into our new web workbook format. Lastly I’m now working on R&S Volume II Lab 1 and will work on both workbooks in parallel.
Please post any comments in regards to this lab here or email them directly to me.
If anyone has time this week and is interested in beta testing the new lab 1 from the R&S Volume III Workbook reply to this post. I would like a few more people to run through it before I release it later this week.
The new R&S Vol III labs are being updated and having VRFs, MPLS, MPLS VPNs, IPv6 OSPFv3 and EIGRP for IPv6 added. Fundamental multicast for IPv4 and IPv6 will also be included in some of the labs. The troubleshooting section has been updated. Along with the initial and final configurations, the configurations are available per section. So if you want to start at route redistribution, BGP, IPv6, etc you can load up to that point. Additionally the route redistribution is being standardized to follow the same methodology that I teach in my bootcamps. I’ve included a detailed walk-through explanation of the route redistribution solution used and why it was selected over other solutions so by the end of all of the Vol III labs you will be able to check route redistribution off your list of topics to worry about in the real lab.
Once the beta is done, grading will be added to lab 1 so you can have your lab graded. It’s going to take me about a week per lab to get these all updated along with adding in grading and finally beta tested before released. In addition to the grading, the show commands from the solutions will be available to compare with the show commands from your lab. This should be available within the next couple weeks for not just these labs but the new Troubleshooting Labs.